Furnace Installation in Lemoore

Lemoore’s NATE-Certified Furnace Installation Team, Serving Kings County Since 2019

When your furnace needs replacing, or you’re installing one for the first time, the equipment matters, but so does who puts it in. Performance Air is a NATE-certified, family-owned HVAC company serving Lemoore and Kings County homeowners since 2019. We install and replace furnaces of all fuel types and service all makes and models, so you can make the right decision for your home before committing to equipment. Free estimates are available on full furnace replacements, and se habla español. We’re fully licensed, bonded, and insured.

Our slogan is High Performance, Higher Standards, and it shapes every job we take on. We’re here to help make sure the furnace in your home is the right one, installed correctly.

Ready to talk through your options? Call (559) 414-8362 to schedule your free furnace replacement estimate with our Lemoore team.

What Sets Our Furnace Installations Apart

A lot of HVAC companies can swap out a furnace. Fewer take the time to do it well. Our technicians are friendly and direct, explaining what they find in plain language without steering you toward a purchase you don’t need. If your existing system can be repaired, we’ll say so. When replacement is the right call, we can walk you through why.

We’re guests in your home, and we act like it. Shoe covers go on at the door, the work area stays clean, and when we leave, your home looks exactly as it did when we arrived, except with a properly installed furnace running at full efficiency.

As authorized dealers for Carrier, Ruud, and Bosch, we have direct access to equipment that matches our workmanship standards. Dealer authorization also means our technicians meet the training requirements those manufacturers set, so the quality of the install reflects the quality of the equipment.

Our Furnace Installation Process

Rushing a furnace installation creates problems that show up later: short-cycling, uneven heat, energy waste, and in some cases, safety hazards. We don’t rush. Every installation follows the same careful sequence.

What our installation process includes:

• Load calculation: We size the system to your specific home, accounting for square footage, insulation, ceiling height, and window area. An oversized furnace short-cycles; an undersized one struggles to keep up. Neither is acceptable.
• Level and secure the base: The furnace is properly leveled and anchored before any connections are made.
• Plenum sealing: All plenum connections are tested and sealed to prevent heat loss and support indoor air quality. Leaky connections waste energy and can allow combustion gases to migrate where they shouldn’t.
• Thermostat calibration: The new thermostat is dialed in for accurate temperature control and peak efficiency.
• Safety checks: We verify every combustion and electrical component before the job is considered finished.
• Homeowner walkthrough: Before we leave, we show you how to operate your new system and answer any questions you have.

NATE Certification & Authorized Dealer Status

NATE, which stands for North American Technician Excellence, is the HVAC industry’s most recognized certification. It means our technicians have passed standardized knowledge and skills testing, not just completed an on-the-job training program. Combined with our authorized dealer relationships with Carrier, Ruud, and Bosch, that translates to verified competence paired with verified equipment quality.

We also service all makes and models, so if your home has a brand we don’t sell, we’re still the right call. Every job comes with upfront, transparent pricing. No hidden fees, no surprises on the final invoice.